Q: When using the shower head for shower, I found that the water is not a thin stream of water in the form of a jet, but a thick water column in some places. What should I do?

A: There are two reasons why the fine water of the shower head becomes a mixture of coarse and fine water. One is that the water spraying method of your shower head is adjustable. You can adjust it by rotating the nozzle. If it is not adjusted, it is caused by too much dirt in the nozzle. Open the small round cap in the middle of the nozzle with a small flat screwdriver, unscrew the screw with a plum screwdriver, open the shower head, rinse it with clean water, brush the shower hole with a toothbrush, and then install it again.

Supplement: Showers with adjustment functions generally have several water discharge methods. Adjusting the adjustment disk will convert the function according to the internal results, such as shower, large and small pulses, and mixed functions.

Q: The shower head is often blocked after being used for a long time. Some holes discharge water, while others do not. What should I do?

A: There are two types of shower nozzles on the market. One is made of hard material, and the dirt can only be removed with a cleaning needle when cleaning. The other is made of soft material, usually silicone, and the dirt can be removed by hand. It is recommended to choose the latter. However, due to the different quality and grades of silicone, you should ask carefully when purchasing.

Supplement: The mask on the shower head generally contains a self-cleaning sheet. The function of the self-cleaning sheet is to adjust the water output and to clean. The self-cleaning sheet is generally made of rubber or silicone.